High Degree NAVIGATOR MC501R 소유자 사용 설명서 - 페이지 9

{카테고리_이름} High Degree NAVIGATOR MC501R에 대한 소유자 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. High Degree NAVIGATOR MC501R 17 페이지.

Navigator Electronics System

In side of battery enclosure lays the heart of the

Navigator: the microprocessor controlled electronics

system. If your Navigator should suffer a fault, there

are four diagnostic lights on the electronics case,

which are there to help you and us. When you

connect the battery, the electronics system will

automatically run through a start up routine. This in

indicated by all of the lights coming on for

approximately 2 seconds. When the start up routine

is complete, all of the lights will go out except the

green 'power on' light.

If the lights fail to go out, check that the safety switch is in the

'on' position. The safety switch should be used when you are

leaving Navigator unattended for short periods of time, for

example if you go into the pro shop for a drink. Green: Power On.

This light will remain on all of the time that the battery is

connected.

Red: Means that battery is flat. In this situation, you can make

use of the 'freewheel' position on the rear wheels and use

Navigator like a regular trolley.

Both Red: If both red lights are on then it means that the

electronics has been overloaded. For example, accidentally

leaving your Navigator running when against a tree or wall will do

this. The LED's will reset to normal when the problem is resolved.

All Lights: The safety switch has been activated. The Navigator

will be respond to any signals until the switch is deactivated. If all

lights are on and the safety switch is activated, you should

Important:

The electronics box contains no user serviceable

parts. The lid to the case is sealed to reduce the risk of water

ingress. Breaking this seal increases the risk of moisture entering

the case, and reduces the reliability of your Navigator. No attempt

should be made to open the case and doing so may invalidate

the warranty.