Autonics SCM-38I 빠른 매뉴얼 - 페이지 9
{카테고리_이름} Autonics SCM-38I에 대한 빠른 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics SCM-38I 11 페이지. Communication converter
Autonics SCM-38I에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지), 제품 설명서 (2 페이지), 매뉴얼 (11 페이지)
페이지 인쇄
Serial Port Driver Installation
1) After installing USB Driver, Serial Port (COM port),
'Found New Hardware Wizard' will appear (Serial
Port Driver installation follows the same procedures
described in installing USB Driver).
2) After selecting 'Install from a list or specific location
(advance)', click 'Next' button. The following window will
be displayed for 'Search and installation options'
3) Because a driver location was selected when installing
USB driver, click 'Next' button.
4)Hardware installation message will appear while Found
New Hardware Wizard is running. Click 'Continue
Anyway' to proceed with installation.
5)'Completing the Found New Hardware wizard' will be
displayed if the Serial Port Driver is installed properly.
Click the 'Finish' button.
Communication Converter
※ Verify that drivers were installed properly with the
windows Device Manager after finishing USB Driver and
Serial Port Driver installation.
Open the folder [My computer], open the system folder
(click right), click the hardware tab, and click the Device
Manager Button. Then, make sure that 'SCM-WF48
Driver(Autonics Corp)', 'SCM-US48I Driver(Autonics
Corp)' or 'SCM-US Driver(Autonics Corp)' is found in
'Common Serial Bus Controller' category and 'Port (COM
and LPT) is found in 'SCM-WF48 Serial Port (COM □)',
'SCM-US48I Serial Port(COM
Port(COM
)'.
※ This Driver Installation is described based on the
procedure for Windows XP.
There might be some differences in the specification
above depending on OS.
(A)
Photo
electric
sensor
(B)
Fiber
optic
sensor
(C)
Door/Area
sensor
(D)
Proximity
) or 'SCM-US Serial
sensor
(E)
Pressure
sensor
(F)
Rotary
encoder
(G)
Connector/
Socket
(H)
Temp.
controller
(I)
SSR/
Power
controller
(J)
Counter
(K)
Timer
(L)
Panel
meter
(M)
Tacho/
Speed/ Pulse
meter
(N)
Display
unit
(O)
Sensor
controller
(P)
Switching
mode power
supply
(Q)
Stepper
motor&
Driver&Controller
(R)
Graphic/
Logic
panel
(S)
Field
network
device
(T)
Software
(U)
Other
S-39