DC Pedals 5-Channel Bluetooth Looper 사용자 설명서 - 페이지 4

{카테고리_이름} DC Pedals 5-Channel Bluetooth Looper에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DC Pedals 5-Channel Bluetooth Looper 12 페이지.

5-Channel Bluetooth Looper

– User Manual

the operation of the footswitches for the new mode. This feature enables you to "play out" of a preset and

make real-time adjustments to your tone if the song flow or set changes. Then with a quick press of the

Mode switch and a Channel switch and you are right back into the preset. This one-button Live Mode feature

is available only in DC Pedals designed loopers.

Bank Switch:

The Bank switch is active in both Live and Preset Modes but behaves differently in each mode. In Preset

Mode, pressing the Bank switch will cycle through the five banks of presets. An RGB LED shows the active

Bank. The color indicators are Blue (1), Green (2), Red (3), Yellow (4), and White (5). There are five Presets

in each Bank.

To change the current Folder, hold the Bank switch for 2 seconds. Loop LEDs 1-4 will light and the currently

selected folder will blink. Press Channel switch 1-4 to select a Folder. The corresponding LED will blink after

the Folder is selected. Also, the corresponding Folder LED will blink each time the Looper is powered ON.

In Live Mode, pressing the Bank switch activities the TIP function on the TRS jack. The TRS functions can be

latching or momentary.

The Tuner Switch:

The Tuner switch is similar to the Bank switch in that it behaves differently in Preset and Live Modes. In

Preset Mode, pressing the Tuner switch mutes the audio at both the input and output of the loops. This stops

any stray audio from getting into your delays and reverbs and keeps your amp quiet. The audio is still sent

through a buffer and to the Tuner-Out jack.

In Live Mode, pressing the Tuner switch activities the RING function on the TRS jack. The TRS functions can

be latching or momentary.

The Tuner switch can be changed to a Bank Down switch by holding the Tuner switch in Preset Mode. This

setting is retained during power cycles.

Channel Switches:

In Live Mode, the Channel switches toggle the corresponding loop on or off. In Preset Mode, the Channel

switches recall the saved preset stored in that preset/bank/folder. In Save Mode the Channel switch will

store the current setting (preset) into that preset, bank, and folder.

To access the TRS TIP function in Preset Mode, press switches 1 & 2 at the same time. LED 4 will blink to

confirm the TIP action. To access the TRS RING function in Preset Mode, press switches 2 & 3 at the same

time. LED 5 will blink to confirm the RING action.

Live Mode:

When in Live Mode, the looper operates just like a traditional true-bypass looper. Each Channel switch

toggles the corresponding loop on/off. The Mode LED is Green when the looper is in Live mode. The Bank

switch activates the TRS TIP function and the Tuner switch activates the TRS RING function.

Preset Mode:

When in Preset Mode, you can use any Channel switch to control any combination of loops. The Channel

switches set the looper to a Preset. A Preset is simply a definition of active loops and TRS functions. No

Page 4 of 12