911SafeTrack S4 설치 매뉴얼 - 페이지 14

{카테고리_이름} 911SafeTrack S4에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 911SafeTrack S4 20 페이지. Vehicle security tracker

Step 6 – Testing Cable

Do not plug the Cable into the S4 Connector.

Using your multimeter or

, check the

computer-safe logic probe

following at the 10-pin connector of the Cable [be careful

not to enlarge or damage the small terminals] –

• Confirm that terminal 4 with the black wire is connected

to vehicle ground using the ohm setting on your multimeter.

• Confirm that terminal 3 with the red wire reads a constant

12-volts whether the ignition key is On or Off using the

voltage setting on you multimeter.

• Confirm that terminal 6 with the white wire reads 12-volts

only when the ignition key is On.

• If you have connected the yellow wire, confirm that

terminal 7 with the yellow wire reads 12-volts and changes

to zero volts only when the horn is sounding. Try this by

arming the vehicle alarm and causing it to sound or using

the keyfob panic button (if provided). If terminal 7 changes

from zero volts to 12-volts when alarm is sounding, you will

need change S4 configuration in Step 7.

If you have connected Out #1 or Out #2, perform the

following checks [Do not plug the Cable into the S4

Connector]:

• To verify Out #1 operation, carefully touch a test wire

connected to vehicle ground to terminal 5 with the green

wire to see that the relay energizes and that the starter

does not operate when the key is turned to start.

911SafeTrack.com