activTek DUCTWORX 소유자 매뉴얼 - 페이지 5

{카테고리_이름} activTek DUCTWORX에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. activTek DUCTWORX 16 페이지.

RECOMMENDED INSTALLATION TOOLS

3 1/2" Hole Saw

for wood or metal

(recommended)

11/32" Open-End Wrench

Installation Requirements

1. Unit should be installed after the air handler in the

HVAC system.

2. The duct work around the installation area should be

clean and dry to insure proper adhesion of the gasket

materials and any tape used.

3. An approximate 3.5" (8.89 cm) opening will need to

be cut into the existing duct work to install the unit

properly.

ELECTRICAL REQUIREMENTS (110 VOLT UNITS ONLY)

• To use the 120 volt plug, be sure to locate the unit within 6 ft. of a standard 120 volt

grounded outlet. Long term use of an extension cord is not recommended due to safety

considerations.

HARDWIRING REQUIREMENTS

For 110 volt units: Black = L1, White = Neutral, Green = Ground

Drill/Power Driver

1/4" Nut Driver Bit

Phillips Screwdriver

You may also need:

Utility Knife

Min. 8" x 8"

Air

Handler

3/8" Drill Bit

(if installing into fiberglass ducting

with toggle bolts)

Tin Snips

(for metal ductwork)

Max. 6 ft.

120 volt

grounded

outlet