High End Systems SHOWGUN 시작하기 - 페이지 2

{카테고리_이름} High End Systems SHOWGUN에 대한 시작하기을 온라인으로 검색하거나 PDF를 다운로드하세요. High End Systems SHOWGUN 2 페이지.

Power Up

To power on the fixture, connect it to an appropriately-rated power source. (200-230V; 50-60Hz

14-12,18A). The fixture will begin an automatic homing process.

Caution!

Disengage Pan and Tilt locks before operating the fixture.

SHOWGUN 2.5 Onboard Menu System

Use LEFT and RIGHT arrows to

move through the current

menu level options

Use the MENU button (on the left

when viewing the display) to

unlock the menu and move back

to the previous menu level

Configuring Your SHOWGUN 2.5 Fixture

To Set the Start Channel on an SHOWGUN 2.5 Fixture:

1. Access the fixture's menu system via the dot matrix display on the fixture's front panel.

Note: Navigation system buttons' functions invert automatically when the

fixture is turned upside down.

2. Unlock the menu system by pressing and holding down the MENU button until the extended

2-line display appears. DMX ADDRESS MENU is the first option at the top menu level.

3. Press the ENTER button to select. The display will show SET DMX START CHANNEL:###. The display

will show the start channel currently assigned to the fixture.

4. Use the UP and DOWN arrow buttons on the Navigation button to select a new DMX start

channel. The display will flash a new option ready for selection.

Note: The last valid Start channel for an SHOWGUN 2.5 fixture is based on the

channel range required by fixture's module configuration. The last valid start

channel for a standard configuration SHOWGUN 2.5 fixture is 486 (512–30+1).

5. Press the ENTER button to accept the new DMX Start channel. The display will stop flashing

when a new option is entered. The new option will not be stored until the ENTER button is

pressed.

Getting Help

You can find SHOWGUN 2.5 information online at www.highend.com/support/ or contact High

End Systems tech support by email at [email protected] or by phone at 1.800.890.8989.

Center Navigation Button

Use UP and DOWN arrows to

select from available value or set-

ting options.

Use the ENTER button (on the

right when viewing the display)

to store a selected menu value

or option.