High End Systems Power Cue Store 사용자 설명서 - 페이지 6

{카테고리_이름} High End Systems Power Cue Store에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. High End Systems Power Cue Store 19 페이지.

General

The Power Cue Store is suitable for use as a backup to any DMX lighting controller,

storing up to 64 scenes of all 512 DMX channels. Install it as the first device in the

DMX chain after the controller.

Alternatively, it can be used as a stand-alone playback unit, once it has been loaded

from a controller or from a memory card.

The Power Cue Store is designed to be rack mounted. It takes up one rack unit of

space, is 7.3 inches (186 mm) deep, and weighs 7.7 pounds (3.5 kg). The 5-pin XLR

DMX connectors and the mains input are mounted on the rear panel. There is also a

25-pin sub-D connector on the rear panel for optional external control by a 10V/12V

analog controller.

CAUTIONS

(1) Refer servicing to qualified personnel; no user serviceable parts

inside.

À l'intérieur de l'équipement il n'y a pas de pièces remplaçables par

l' utilisateur. Confiez l'entretien à un personnel qualifié.

Derive el servicio de reparación de este equipo al personal calificado. El

interior no contiene repuestos que puedan ser reparados por el usuario.

(2) This equipment is to be used at 120VAC only. Verify the rating of the

power source before you plug it in. Damage to the equipment could

occur if used at an incorrect rating.

Aviso!

Este Aparato solamente puede ser usado a un maximo de 120VAC. Veri-

ficar el poder del voltage antes de conectarlo. Posible danos

pudieran ocurrir si se usa a otro voltage.

This section discusses the five operating modes of the Power Cue Store:

Page 4

Scene loading mode

Manual control mode

External control mode

Power Cue Store

User Manual