Autonics ADIO-PN 제품 설명서 - 페이지 6
{카테고리_이름} Autonics ADIO-PN에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autonics ADIO-PN 10 페이지. Remote i/o boxes (profinet)
Autonics ADIO-PN에 대해서도 마찬가지입니다: 제품 설명서 (10 페이지)
페이지 인쇄
Device Name Settings
To connect to the PROFINET network, configure the PROFINET interface. The PROFINET device name can be configured using the following methods.
■ Rotary switches
Be sure to place the seal of the protective cover firmly on the rotary switches after completing the settings.
The protection rating is not guaranteed when the protective cover is open.
x100
x10
01. Rotate the rotary switches to set the device name. The green LED of the US indicator flashes.
Setting mode
Rotary switches
000
PROFINET Device Name
001 to 999
02. Turn on the ADIO-PN again.
03. Check that green LED of the US indicator is ON.
04. The device name has been changed.
05. Put the protective cover on the rotary switches.
■ atIOLink
The PROFINET device name configured by the atIOLink software is stored in the ADIO-PN's EEPROM. For more information, refer to the atIOLink User Manual.
x1
Description
This device name is stored in the ADIO-PN's EEPROM.
Applying the device name configured on the PROFINET Master or DCP tools.
Establish the communication connection after setting the ADIO-PN's device name.
The value of rotary switches is displayed at the last of the device name.
Value
PROFINET device name
ADIO-PN-MA08A-ILM-□□□