iHealth Clear 빠른 시작 매뉴얼
{카테고리_이름} iHealth Clear에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. iHealth Clear 2 페이지.
페이지 인쇄
Measurement
EN
1
Rest your bare (or thinly clothed) left arm flat on a table.
Clear
Quick Start Guide
2
Note the direction of the
cuff tubing and alignment
with your middle finger.
Fully charge the blood pressure
monitor before first use.
3
The bottom of the cuff should be about 1/2" above your
elbow. Tighten the cuff firmly, leaving about 1 finger space.
Place cuff over left arm so the cuff tubing is centered on the
inside of your arm and aligned with your middle finger.
4
Insert cuff tubing connector into blood pressure monitor
unit, and the monitor will power on automatically.
Make sure to fully insert the
cuff tubing connector into
the blood pressure monitor.
5
You will need to select your language after turning on the
monitor for the first time.
English
Français
Deutsch
Italiano
Press to change
language
1/2 inch (1-2 cm)
6
Press User 1 or User 2 button again to start a measurement.
Press any button to stop a measurement and to turn off the
monitor.
During the measurement, you will feel the cuff tightening
around your arm. Remain still and do not move your arm
until the measurement is complete.
Wireless Network Setup
1
Go to the Apple App Store or Google Play Store and search
"iHealth MyVitals." Download the app and then log in.
Press to confirm
language
2
Press and hold the User 2 button for 10 seconds until the
screen displays the select language page.
English
Français
Deutsch
Italiano
Press to change
Press to confirm
language
language
3
The screen will display the wireless network setup page.
Launch the iHealth MyVitals app, go to Select New Devices
and choose Clear (BPM1). Follow the on-screen instructions
to finish setting up your wireless network.
Connecting WiFi...
Ready to connect, launch MyVitals
app.
Setup complete! Your blood pressure
measurements will automatically
upload to the iHealth MyVitals app.