DCA M1Q-FF-85 사용 설명서 - 페이지 9

{카테고리_이름} DCA M1Q-FF-85에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCA M1Q-FF-85 10 페이지.

MAINTENANCE AND INSPECTION

CAUTION:

Always be sure that the tool is switched off and unplugged before attempting to

perform inspection or maintenance.

After Metal Cutting

When cutting metals under extreme working conditions, conductive dust can

accumulate in the interior of the machine and impair its protective insulation.

In such cases, it is recommended to use stationary dust extraction equipment,

to blow out the ventilation slots frequently and to power the tool via a ground

fault circuit interrupter.

Inspecting the Mounting Screws

Regularly inspect all mounting screws and ensure that they are properly

tightened. Should any of the screws be loose, retighten them immediately.

Failure to do so could result in serious hazard.

Maintenance of the Motor

The motor unit winding is the very "heart" of the power tool. Exercise due care

to ensure the winding does not become damaged and /or wet with oil or water.

Always keep the power tool and its ventilation slots clean.

Inspecting of the Blade Roller Guide

The blade roller guide should occasionally be checked for wear and lubricated

with a drop of oil. If it is worn, it must be replaced.

Inspecting and Replacing Carbon Brushes

Remove and check the carbon brushes regularly. Replace when they wear

down to the limit mark. Keep the carbon brushes clean and free to slip in the

holders. Both carbon brushes should be replaced at the same time and use

only identical carbon brushes.

※ ※ ※ ※ To maintain product SAFETY and RELIABILITY, repairs, any other maintenance

or adjustment should be performed by authorized centers, always using original

replacement parts.

-15-

-16-