DCB PTT24 매뉴얼 - 페이지 12
{카테고리_이름} DCB PTT24에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCB PTT24 12 페이지. Push-to-talk lockout device
DCB PTT24에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄Appendix A
Specifications
PTT24 Push-to-Talk Lockout Device Specifications
General
Front Panel (these are approximate placements, subject to relocation):
•
- Toggle switch to select 12 or 24 E&M ports
- Push button switch to select port 1 to 24 for PTT Lockout control
- Test switch, momentary, to test lockout function
•
- Front panel switch to kill an audio alarm that will sound when/if the control port activates
- Green Power LED (flashes if an invalid control port number is selected, i.e. 00, 25, etc.)
- Red "ALARM" LED to indicate the PTT Lockout switch is activated
- Yellow "ACO" LED to indicate the ALARM CUT OFF is on
•
Rear Panel
•
- 2 rear panel power inputs for -48 VDC power, diode protected between the 2 power inputs
•
to avoid power feed back
- Alarm Input (dry contact closure) to externally activate the PTT Lockout function and/or
•
test the unit
- Alarm output dry contact
•
- Female 50 pin telco connector from the channel bank, screw connection and cable tie type
•
of cable cable fasteners
- Male 50 pin telco from the PTT lockout to Transmitter side of the circuit, screw connection
•
and cable tie type of cable fasteners
Physical/Electrical
Standalone or rack mounting
•
Power requirements: -48 VDC
•
19" W x 10" D x 1 ¾" H
•
3 pounds
•
Environmental
Operational Temperature: -40 to +70 C
•
Storage Temperature: -50 to +75 C
•
Humidity: <95% Non-condensing
•
10