Dynascan PMR446 사용 설명서 - 페이지 11

{카테고리_이름} Dynascan PMR446에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynascan PMR446 16 페이지. Handheld transceiver
Dynascan PMR446에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 사용 설명서 (10 페이지)

페이지 인쇄
Dynascan PMR446 사용 설명서
Default: OFF.
Menu 12: Auto lockout (AUTO LOCK):
The keypad will be locked after 15 seconds.
Settings: ON/OFF.
Default: OFF.
Notes:
- Press and hold the [EXIT] key for 2 seconds to unlock the keyboard.
- All keys except the [PTT] and the channel selector are locked in the lockout
mode.
Menu 13: RX CTCSS (R-CTC):
Settings: OFF/50 groups of standard CTCSS or non-standard analogue codes from 60.0 to
259.9 Hz.
Default: OFF.
Menu 14: TX CTCSS (T-CTC):
Settings: OFF/50 groups of standard CTCSS or non-standard analogue codes from 60.0 to
259.9 Hz.
Default: OFF.
Menu 15: RX DCS (R-DCS):
Settings: OFF/105 groups of digital standard DCS codes or non-standard from 001 to 777.
Default: OFF.
Notes:
- Press the [MENU] key and then the [PF2] key to select the positive or negative
code.
- 001-777 except codes including 8 or 9, ie. 680/719 is illegal non-standard codes.
- Non-standard DCS codes are programmed by software.
Menu 16: TX DCS (T-DCS):
Settings: OFF/105 groups of digital standard DCS codes or non-standard from 001 to 777.
Default: OFF.
Menu 17: Scan mode (SC-REV):
Settings: TO/CO/SE.
Default: SE.
TO: Scanning will stop when a signal is received and will resume automatically after 5
seconds if no operation is performed on the transceiver. Press [PTT] to turn off scan
function.
CO: Scanning will stop when a signal is received, it will resume automatically after 3
seconds when the signal disappears. Press [PTT] to turn off the scan function.
SE: Scan will stop when receiving a signal.
English - 11 -