Dynaset 60 설치 매뉴얼 - 페이지 9

{카테고리_이름} Dynaset 60에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynaset 60 16 페이지. Hydraulic variable displacement pump

3. Install the pump to its place. Make sure that the drain line is above or at least at the

horizontal level with the axel. If the pump is installed drain line being under the

shaft it can damage the pump.

4. Install the pressure (P), drain (Dr), LS- (LS), and the suction (S) lines

5. Install the rest of the system and fill the system with oil.

6. After installing the rest of the system and filling it with oil run the system with idle

speed for 10 min at pressure being under 50 bar.

Bleeding/flushing the system is recommended before the full pressure range is

used.

Dynaset Oy | Menotie 3, FI-33470 Ylöjärvi, Finland | tel: +358 3 3488 200 | [email protected] | www.dynaset.com

HYDRAULIC VARIABLE DISPLACEMENT PUMP

INSTALLATION GUIDE