Autool CT-200 매뉴얼 - 페이지 11

{카테고리_이름} Autool CT-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 18 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지)

페이지 인쇄
Autool CT-200 매뉴얼
d. Fasten the injector on the machine (see Fig. above).
3.3.2 Steps
11 Reverse Flushing
1) Connect black hose (outlet) to inlet port of the fuel distributor, and
then connect the actuation cable to the machine.
2) Press Left or Right arrow key to select Reverse Flushing.
3) Press RUN key (default test time is 1 minute).
4) Turn Pressure Adjusting Knob until the pressure is 0.25-0.3MPa.
5) When the working time is over, the machine will stop.
6) Release the fluid into the pump after test is completed.
Note：
1. Only up-inlet injector can fit Reverse Flushing.
2. Need not set up pulse width, system use default value.
3. Please make sure the test fluid is clean, so that the injector will not be
blocked.

3.4 Non-dismantle Cleaning(optional function)

To clean the whole fuel system of the engine, including fuel supply system,
burning room and the injector.
3.4.1 Preparation
1) Move the screw on the bottom of test fluid bottle, and release all test
fluid.
2) Open the cover of the engine chamber. Find out the fuel supply hose
and return hose of the fuel system.
3.4.2 Steps
.
- - 11 - -