Autool CT-200 매뉴얼 - 페이지 4

{카테고리_이름} Autool CT-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 18 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지)

Autool CT-200 매뉴얼
2)Connect the machine to power supply and turn it on.
3)Put the cleaning frame on the ultrasonic groove, and put the injector
into the whole of the frame.

3.1.2 Steps

01 Ultrasonic Cleaning
1)Pour proper quantity cleaning fluid into ultrasonic groove.
2)Connect the actuation cable to the injector needed to be cleaned.
3 ) Press Left or Right Arrow key to select "Ultrasonic Cleaning" from
panel, then press "RUN"key.
4) Press Left or Right Arrow key to set up working time( default time is 10
minutes).
5)Press "RUN"key. (You can press PAUSE or STOP at any time during the
operation process.)
6)After the cleaning is completed, it will stop automatically.
7)Take the injector out of the ultrasonic groove.
NOTE:
1. During the cleaning, get the injector close to ear, listen carefully, you
may hear the intermittent sound of closing and opening of the
injector's valve, otherwise the injector's valve is blocked.
2. Please do not turn on the ultrasonic trough when there is not clean
fluid in the trough, otherwise the machine will be damaged.

3.2 Injector Test

This function is to test the condition of atomization, drop, block, spray
angle, and uniformity of the injector.
- - 4 - -