Autool CT-200 매뉴얼 - 페이지 8
{카테고리_이름} Autool CT-200에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 18 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 사용자 설명서 (14 페이지), 사용자 설명서 (14 페이지)
페이지 인쇄
seconds.)
2. System will automatically simulate 3 times accelerating cycle from 750
RPM to 7500 RPM to test the injection condition of the injector.
06 Shifting Speed Test
1) Press Left or Right Arrow key to select Shifting Speed Test.
2) Press RUN key.
3) The next steps are the same as what listed in 02 Idle Speed Test.
NOTE：
1. System pressure, working time and pulse width are set up
automatically by system itself. (Default working time cycle is 10
seconds.)
2. System will automatically simulate 3 times of engine condition of 750
RPM, 4000RPM, and 7500 RPM to test the injection condition of the
injector.
07 Leakage Test
1) Press Left or Right Arrow key to select Leakage Test.
2) Press RUN key.
3) The next steps are the same as what listed in 02 Idle Speed Test.
NOTE:
1. Default pulse width is 3ms.
2. System simulates 0.3Mpa system pressure to test leakage.
08 Idling Spray Value Test
1) Press Left or Right Arrow key to select Idling Spray Value Test, then
press RUN key.
- - 8 - -