Autool CT-200 사용자 설명서 - 페이지 9

{카테고리_이름} Autool CT-200에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT-200 14 페이지. Injector cleaner & tester
Autool CT-200에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지), 사용자 설명서 (14 페이지)

페이지 인쇄
Autool CT-200 사용자 설명서
3) The rest of the operation steps are consistent with item 02
04 High speed test
1) Select "04 High Speed Test".
2) Press the start button.
3) The rest of the operation steps are consistent with item 02
05 Accelerating test
1) Select "05 Accelerating Test".
2) Press the start button.
NOTICE
● The fuel pressure, working time and pulse width are automatically set by the
system. The time system defaults to 10s as a cycle period, and the user does not
need to set it separately.
● The system will automatically and continuously cycle three times to simulate
the working condition and fuel injection volume of the fuel injector when the engine
is accelerating uniformly at 750 to 7500 rpm.
06 Variable speed test
1) Select "06 Variable Speed Test".
2) Press the start button.
NOTICE
● The fuel pressure, working time and pulse width are automatically set by the
system. The time system defaults to a cycle of 10s, and the user does not need to
set it separately.
● The system will automatically and continuously cycle three times to simulate
the working condition and fuel injection volume of the fuel injector when the engine
is idling (750 rpm), medium speed (4500 rpm), and high speed (7500 rpm).
07 Leakage test
1) Select "07 Leak Test".
2) Press the working time up and down buttons to set the time. (Generally set to 1
minute)
3) The rest of the operation steps are consistent with item 02.
NOTICE
● The pulse width system defaults to 3ms, no need to set it again.
● Whether the fuel injection nozzle is dripping and leaking when the simulated oil
pressure is 0.3Mpa
08 Idle speed spray volume test
1) Select "08 Idle Spray Volume".