Autool CT150 사용자 설명서 - 페이지 8

{카테고리_이름} Autool CT150에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autool CT150 14 페이지. Fuel system cleaner

페이지 인쇄

Up-inlet injector installation method and testing steps

Select the oil separator from the accessory box, select

the matching "O" ring and install it on the blockage, and

apply a little grease to load the plug into the oil separator.

Install the crescent-shaped pressure plate and tighten the

platen screws.

According to the type of nozzle connection, select the

appropriate straight oil connector to be installed at the

corresponding coupler under the oil separator.

Install the injector in the forward direction (apply a small

amount of grease on the "O" ring of the injector).

According to the height of the injector, select the

appropriate adjusting screw and knurled nut to install on

the oil separator bracket. Then install the oil separator

and fuel injector on the oil separator bracket and evenly

tighten the two knurled screws (black). The installation

diagram is shown in Figure.03.

Insert the injector pulse signal line.

If there is a test solution in the test cup, press the

[Oil drain] button to drain the test solution from the test

cup.

Select the uniformity/atomization detection in the control

panel, set the corresponding working condition parameters,

and press the [Run] key

(Note:During operation, press the [Oil drain] key to perform

uniformity and atomization. Switching between each other).

After

the

test

completed,

automatically and beep with a buzzer.

1-Platen

screw;

2-Knurling

screw; 3-Moon tooth plate; 4-Oil

separator is blocked; 5-Straight

oil connector; 6-Top fuel supply

nozzle; 7-Knurled nut;

8-Adjustment screw

Side- inlet injector installation method and testing steps

Select the appropriate side oil supply nozzle from the

accessory box (select the appropriate "O" ring on the

coupling and apply a little on the "O" ring of the coupling

and injector) Grease).

Insert the injector into the coupling and load it into the oil

separator together.

Install the cross platen and tighten the platen screws.

Install the oil separator and fuel injector on the oil separator

bracket

and

evenly

tighten

(black).The installation diagram is shown in Figure.04.

Insert the injector pulse signal line.

If there is a test solution in the test cup, press the

[Oil drain] button to drain the test solution from the test

cup.

the

system

will

stop

Figure.03

the

two

knurled

screws