Emerson Rosemount 648 빠른 설치 매뉴얼 - 페이지 5

{카테고리_이름} Emerson Rosemount 648에 대한 빠른 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson Rosemount 648 18 페이지. Wireless dam monitor (wdm)
Emerson Rosemount 648에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (14 페이지)

페이지 인쇄

Quick Installation Guide

00825-0100-4648, Rev CC

February 2012

TEP

CONTINUED

5. Close the housing cover and tighten to safety specification. Always ensure a proper seal

by installing the electronics housing covers so that metal touches metal, but do not over

tighten.

6. Position the antenna such that it is vertical, either straight up or straight down. The

antenna should be approximately three ft. (0,91 m) from any large structures or

buildings, to allow clear communication to other devices.

Remote Mount

1. Install the sensor according to standard installation practices. Be sure to use an

approved thread sealant on all connections.

2. Run wiring (and conduit, if necessary) from the sensor to the 648.

3. Pull the wiring through the threaded conduit entry of the 648.

4. Attach the sensor wiring to the terminals as indicated on the wiring diagram.

5. Connect the Power Module.

NOTE:

Wireless devices should be powered up in order of proximity from the Wireless

Gateway, beginning with the closest device to the Gateway. This will result in a

simpler and faster network installation.

...

Possible antenna rotation shown.

Antenna rotation allows for best

installation practices in any

configuration.

Possible antenna rotation shown.

Antenna rotation allows best

practices for any configuration.

Rosemount 648 Wireless