Autopage RS-602 설치 매뉴얼 - 페이지 7

{카테고리_이름} Autopage RS-602에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RS-602 16 페이지. Professional remote car starter
Autopage RS-602에 대해서도 마찬가지입니다: 운영 매뉴얼 (8 페이지)

페이지 인쇄

To: White/Black Wire /

Negative safety

BLACK/WHITE WIRE

(-)Neutral Safety Switch Input

H3/4

(-)Remote Start Enable Toggle Switch Input

When the BLACK/WHITE wire is grounded, the remote start unit is operable. When this wire is open from ground, the

remote start is disabled. This wire must be connected to the vehicles Neutral safety switch!

1. The optional "remote start toggle switch" can be added on to temporarily disable the Remote Start Device, it can

prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or

stored in an enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the OFF

position. To enable the remote start, move the optional remote start enable toggle switch to the ON position.

2. This wire MUST be connected to the PARK/NEUTRAL switch in the vehicle. (See the TESTING YOUR

INSTALLATION GUIDE)

IMPORTANT NOTE: Directly connect the BLACK/WHITE wire to the "GROUND" when this wire is not used.

H3/5. WHITE/VIOLET WIRE : Positive safety shut down input

This wire provides an instant shutdown for the remote start, whenever it gets +12volts. If the brake lights switch in the

vehicle switches +12 volts to the brake light circuit, connect this wire to the output side of the brake switch. This will allow

the remote start to shut down if an attempt is made to operate the vehicle without the key while running under the control

of the remote start. In most vehicles, in order to shift gear, the brake pedal must be depressed. The brake input will in turn

cause the remote start unit to shut off. See below diagram.

Switch closes when

brake is depress

H3/6. GRAY WIRE : (-)200mA Chaneel #3 output -

This will become a 1 second pulse ground by activate channel 3 on transmitter for two seconds, the current capacity

of this wire is 200 mA. This feature allows you to remote control trunk release or other electric device.

H3/7. WHITE WIRE: (-) 200 mA Ground output while the engine is starting or running. This wire can be used

to activate a by-pass module and will provide a ground output when the engine is starting or running

from the remote starter.

H3/8 PINK WIRE : (-) 200ma PROGRAMMABLE OUTPUT

FACTORY SECURITY DISARM SIGNAL OUTPUT –(Factory Default Setting) --

This wire is designed to disarm a factory installed security system. This wire sends a negative (-) 1 second pulse

upon a remote start and remote door unlocking. Some factory systems must be disarmed to allow remote starting. In

most cases, this wire may be connected directly to the factory alarm disarm wire. The correct wire will show nagative

ground when the key is used to unlock the doors or trunk. This wire is usually found in the kick panel area in the

wiring harness coming into the car body from the door.

START STATUS (Shock Sensor Bypass Control) OUTPUT–

RS-602 REV A.

Hood Pin Switch

Diode

To Vehicle Brake Switch

+12 volts from fuse box

To White/ Violet

Brake light bulbs

(See Alarm Feature I - 2 Programming)

6/18/2007

wire