Autopage RS-777 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Autopage RS-777에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RS-777 14 페이지. Remote engine starter with alarm system

페이지 인쇄

The siren will chirp once and parking light will flash once indicating that the system is now armed. The vehicle's

doors will lock upon arming if interfaced with the security system.

DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps and parking light flash one time, then you have left a

door, trunk, or hood lid ajar.

SILENT ARMING / DISARMING: Press the transmitter

security system, No chirp sound will be heard, arm / disarm confirmation will be through the vehicles parking lights

only.

SENSOR BY-PASS:

The sensor bypass feature is programmed to activate for one arming cycle only. The security system will

return to normal operation during the next arming cycle.

Sensor By-Pass :

By 2-way HHU operation Table – 1 PASS 1 icon on, or press the

arm the security system and Bypass sensor 1 (zone 4 shock sensor).

HIDDEN ALARM FUNCTION:

By 2-way HHU operation Table -1-2

seconds press the

"Hidden Alarm Function" The siren / horn will be silenced even if the sensor is triggered in the armed status.

Alarm indication will only appear on the LCD.

F. PASSIVE ARMING

Active arming / disarming is controlled by your security system via the remote transmitter. This security system is

equipped with an optional Passive Arming feature, which allows the security system to arm 30 seconds after the last

door is closed. Operation is as follows.

1. Turn the ignition to the "OFF" position and exit the vehicle.

2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any door / hood

/ trunk, the security system LED will stop flashing. It will begin flashing again once all vehicle entrances are closed.

3. After 30-second timer has elapsed, the security system will automatically "ARM". The siren will chirp [1] time and

the parking lights will flash [1] time.

PASSIVE ARMING WITH PASSIVE DOOR LOCKING

The vehicle doors will automatically lock after the passive arming cycle has been completed.

PASSIVE ARMING BY-PASS: While the system is disarmed, Press the

with [1] chirp and LED will turn "ON". The security system will remain in this temporary state for as long as you wish.

To exit passive by-pass, press the transmitter

G. ACTIVE DISARMING – UNLOCK & DISARM:

1. Press

button on the transmitter.

2. The siren will chirp twice and the parking lights will flash twice indicating that the security system is now disarmed.

The vehicle's doors will unlock and the dome light will turn on for 30 seconds upon disarming. (Note: Power door

locks and dome light must be installed with the security system.)

TAMPER DISARMING: If the alarm is triggered upon disarm, the system's siren will chirp 4 times, and the parking

lights will flash 3 times.

PATHWAY ILLUMINATION: When receiving an unlock /disarm signal, this feature will turn the parking lights "ON" for

30 seconds and for 10 seconds upon the lock signal.

TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver's door only when disarming the

security system. Pushing the

AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically re-arm itself in 60 seconds

after disarming with remote transmitter. Automatic rearm will cancel if any door is opened before the 60 seconds timer

has elapsed.

H. DISARMING WITHOUT A TRANSMITTER

OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE:

(Factory Default Setting)

The Override function may be used if the remote transmitter is lost or inoperative.

1. Enter the vehicle and turn the ignition switch to 'ON' position.

2. (Alarm will sound.)

3. Within 10 seconds push and release the valet switch. The alarm will stop sounding and enter the disarm mode. You

can now start and operate the vehicle normally.

OVERRIDE THE ALARM WITH PASSWORD PIN CODE:

Unlike valet switch easily found, and defeated, this security system allows the consumer to program a password pin

code. Offering a higher level of security.

1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)

2. Within 5 seconds, enter your chosen first digit code by pressing and releasing the Valet Switch. (When finished

above procedures, system's siren will stop alarming, lights will stop flashing, but the vehicle can't be started.)

3. Within 15 seconds of the last digit code enter (the 1st code), then turn the Ignition Switch "OFF" and then "ON".

Within 15 seconds, enter your chosen second digit code by pressing and releasing the Valet Switch.

5. Turn the ignition switch "OFF" position. 4 Chirps from siren/horn and 3 flashes from the parking light indicate the

system has disarmed.

RS-777 OP REV 1D

icon on, Or by remote operation press the

button to activate the hidden alarm function. The security system will arm and with

button a second time within 3 seconds will unlock the other doors.

and

buttons at the same time will arm or disarm your

button two times within 5 seconds will

button twice, the system will respond

buttons and the system will return to normal status.

2013/05/29

button first; within 3