Autopage RF-303 사용 설명서 - 페이지 11

{카테고리_이름} Autopage RF-303에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RF-303 18 페이지.

The RF-303 transmitters are capable of controlling separately installed RF-300,

RF-500, or RF-700 series alarm systems in two vehicles.

To code the RF-303 transmitters for two vehicles, follow the diagrams as shown

below. Before multiple vehicle programming can be achieved, it will be

necessary to enter the programming mode for each vehicle's alarm system.

NOTE: Program each vehicle separately. Do not enter the program modes on

both vehicles at the same time.

1. TWO VEHICLE OPERATION

VEHICLE #1

Enter the programming mode on vehicle #1 and push the ON/OFF button on the

transmitter for vehicle #1. The vehicle horn, or siren will respond with a

confirming chirp. Within five (5) seconds, push the AUX button on one of the

transmitters from vehicle #2. The vehicle horn, or siren will respond with a

confirming chirp. Both transmitters are now programmed to vehicle #1.

VEHICLE #2

Enter the programming mode on vehicle #2 and push the AUX button on the first

transmitter used for vehicle #1. The vehicle horn, or siren will respond with a

confirming chirp. Within five (5) seconds, push the ON/OFF button on the

second transmitter that had been previously programmed on vehicle #1. The

vehicle horn, or siren will respond with a confirming chirp. Both transmitters are

now programmed to

vehicle #2.

NOTE: In the boxes below, the first transmitter is assumed to be the primary

transmitter of vehicle #1, and the second transmitter is assumed to be the primary

transmitter of vehicle #2.

TRANSMITTER #1

TRANSMITTER #2

VEHICLE #1

VEHICLE #2

ON/OFF Button

AUX Button

ON/OFF Button