Autopage RS-600 운영 매뉴얼 - 페이지 6

{카테고리_이름} Autopage RS-600에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopage RS-600 9 페이지. Professional remote car starter & keyless entry system

light will turn on again and climate controls will activate and adjust

the vehicles interior temperature to your preset setting.

5. The vehicle will run for 5 to 30 minute cycle and automatically shut

down. The duration of the starting mode is programmable.

(SINGLE PUSH START OPERATION:)

The programmable feature allows you to press the

before the vehicle will remote start or remote shut down. (Programming

Required)

NOTE: The Remote Start Unit will not start the vehicle if any one of the

following conditions exists:

1. The hood is opened.

2. The brake pedal is pressed.

3. Move the optional remote start enable toggle switch to OFF position.

(If installed)

4. The gear selector is in any gear other then "PARK" or "NEUTRAL"

TO TURN OFF THE REMOTE START:

When the engine is running (by remote start), if you want to stop it,

1. Press

button once on the transmitter.

2. Move the optional remote start enable toggle switch to OFF position.

(If installed)

3. Press the brake pedal, the vehicle will shut down and turn off the

parking light to indicate engine stopped.

TO OVERRIDE VEHICLE FROM REMOTE START CONTROL:

To operate the vehicle while running from a remote start condition.

1. Insert the ignition key and turn it to "ON" (not the start) position.

2. Press the brake pedal.

Note: If the brake pedal is pressed before the key is in the ON

position, the engine will shut down.

This feature allows the vehicle to remain running after the key has been

removed from the ignition. This feature is useful for occasions when you

wish to exit and lock the vehicle for short periods of time, but would like

to leave the engine running and the climate control on.

1. Before turning off the engine, press the

transmitter. The parking lights will come on and the LED will flash 3

times to confirm Temporary Stop feature 'ON'

2. Turn the ignition key to OFF position. (The engine will stay running.)

3. The engine will run until the pre-programmed time elapsed or

shutdown input is received.

button twice on the

button once