Gale Pacific Coolaroo SOLAR MOTORISED 490942 조립 및 작동 지침 - 페이지 4

{카테고리_이름} Gale Pacific Coolaroo SOLAR MOTORISED 490942에 대한 조립 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Gale Pacific Coolaroo SOLAR MOTORISED 490942 8 페이지. Exterior blind

페이지 인쇄

STEP 4

Position the solar panel clip onto the mounting

bracket and secure into position using the screw

and nut. Do not yet tighten.

Use the timber screws to mount the solar bracket

into a position near the pelmet that attracts the

most amount of sunlight. If mounting to masonry,

use the 5mm wall plugs.

Fit the solar panel into the clip, making sure the

power cord is on the right hand side.

NOTE: Ensure the solar panel mounting location

is close enough to allow the 2m cable to reach the

connection point on the motor.

Run the power cord along the top of the pelmet and

connect it to the motor.

Tilt the solar panel to an angle that will receive the

most sunlight, then fully tighten the screw.

STEP 5

To power up your solar motorised blind for the first

time press the motor program button once on the

right hand side of the blind. The blind will move to

the bottom position. Once it has stopped, it is ready

for use.

PROGRAMMING THE REMOTE

CONTROL

To program the remote control you will need to

access the program button which is located on

the inside of the remote control.

Using a Phillips-head screwdriver undo the screw

on the back of the remote control and remove

the casing. Take note of the program button.

NOTE: The remote control is fitted with a battery

isolation tag that will need to be removed and

disposed of prior to operating the remote control.

Remote control

program button

Press motor

program

button once