High Tech IVC-45L 매뉴얼 - 페이지 11
{카테고리_이름} High Tech IVC-45L에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. High Tech IVC-45L 12 페이지. Industrial vacuum cleaner
페이지 인쇄
To clean the filter element thoroughly, remove the filter element for cleaning.
Press emergency stop button and unplug power supply to stop the
the device to transportation position.Loosen the three tower buttons on the filter
cover and turn the filter counterclockwise to remove it.
5.4 Overloading Protection
The electric control box is equipped with a thermal relay. When the current exceeds
the set value, it will enter the overload
control box and press the reset button to solve it.
5.5
Maintenance items
Any repairs must be performed by Pantheon Service Center training service
personnel and use original
Pantheon accessories. If your machine needs repair, please contact with your
retailer.
machine.
protection.
In this case, just open the electric
6. Frequently Asked Questions & Solutions
Adjust
This chapter describes some of the possible failures and how to handle them. If you
still cannot resolve or have an
Problem
Machine cannot start
The vacuum cleaner stops
after starting
The machine uttered a low
buzz when turn on and turn
off
The machine is blowing, not
sucking.
Poor suction performance
The machine is blowing
dust
Cyclone separation bucket
does not work
error,
please contact your nearest
retailer.
Possible reason
The machine does not receive
Connect the power cable to
or output power
machine and start up
Motor protecting has tripped
For the operation steps,see 5.5
Overloading Protection
Cable damages
Contact a licensed electrician
Control circuit damage
Contact a licensed electrician
or Pantheon Service center
Some objects obstruct airflow
Clean hoses, filters etc.
Relay overload protection
For the operation steps,see 5.5
Overloading Protection
Phase lost input, currently only
Contact a licensed electrician
or check the input power has
two phase inputs. Turn off the
three -phase input.
machine to avoid burning the
motor.
Dust in the motor impeller
Contact a licensed electrician
Motor burned
down.
Contact a licensed electrician
or Pantheon Service center
Contact a licensed electrician to
Phase relay failure
adjust the position of L1 and L3
wires on the power plug and
replace the phase relay if
Maybe that the vacuum system
Check and repair the seal.
is not
sealed.
Use a compressed air or brush
Cyclone separator or filter
to clean the cyclone and filter.
Hose blockageis not
sealed.
Shake suction pipe wavily
Incorrect installation of the filter
Install the filter correctly
Filter has been dislocated
Reinstall the filter
The filter is broken
Replace with new filter
The dust is too light and too
thin
Clean the cyclone( see above).
Cyclone blockage
Solution
necessary.
18