Galene GS1 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Galene GS1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Galene GS1 17 페이지. Whole house water filter

OPERATION AND MAINTENANCE MANUAL

WATER FILTRATION SYSTEM

Site Preparation

 Locate where the main water line enters your home.

 Define the most convenient location to install the unit. In cold climate conditions,

install inside a protected area, or risk freezing and rupturing during winter time

with severe damage to the system. In hot weather conditions, keep away from

direct exposure to sunlight.

 Stage the unit to make sure all pieces will fit in the desired location.

 Dimensions of units vary. Make sure you allow clearance to service the unit if

required. It is advisable to leave 48" clearance above tank, and 24" on floor space,

on sides and front of unit.

 Make sure you purchased required material for connecting the main water line to

the inlet/outlet connection to the system. Take into consideration the pipe

materials when defining what to buy.

Important Notes:

1. Assure the correct sequence is followed. Improper sequence of the filters will

affect performance and may damage the unit.

2. System is designed to operate between 20 psi – 80 psi. DO NOT exceed 100 psi in

any case.

3. System is designed to operate on cold water lines only (40 deg – 80 deg). DO NOT

install after water heater or on a hot line.

4. System shall always be installed upright.

5. If installing on metallic based pipes (copper pipe included), grounding clamps

with a #4 copper wire is required, tying the two ends of the pipe, otherwise you

risk electric shock hazard.

6. System should be installed in a protected area. Prolonged exposure to direct

sunlight damages components, and freezing temperatures expose the unit to

freezing and consequent rupture.

7. Make sure you comply with all state and local plumbing codes, use appropriate

tap for sealing, and properly tighten all fittings to ensure a leak-free assembly.

Anticipate the need of parts to finish the installation process, including required

material for hook-up to your main water line as well as additional pipe and

fittings if the installation kit is not purchased or the site requires change in

layout.