Dynasplint Type II 피팅 지침 매뉴얼 - 페이지 3

{카테고리_이름} Dynasplint Type II에 대한 피팅 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynasplint Type II 8 페이지. Wrist extension system

페이지 인쇄

STEP 7: Position patient to view splint as in Figure 2. Close bottom-of-forearm cuff

to position palmar bar and allow adequate wrist clearance, loosen the set

screws with adjustment tool. See Figure 3-B.

STEP 8: Lengthen or shorten horizontal bar by expanding or retracting bar until wrist

adequately clears cam. Next, slide and align the vertical post with the palm's

midline. Tighten set screws gently.

STEP 9: Close counterforce strap and readjust top-of-forearm cuff.

STEP 10: Adjust stem rod height. Loosen set screws that hold the stem. See Figure 3-C.

With patient's fingers in a relaxed, semiflexed posture, position palmar bar in

the palm of hand. Tighten screws gently.

STEP 11: Adjust rotational angle of palmar bar by loosening wrist pivot assembly to

obtain comfortable position. See Figure 3-D. Tighten screws.

STEP 12: Adjust tilt of palmar bar by using the hex wrench to loosen sagittal screw.

See Figure 3-E. Tighten screw firmly.

FIgurE 3.

Struts

STEP 13: Take unit off and set the tension to the proper setting. See Protocol.

STEP 14: Reapply unit and check the alignment with Figure 2, making sure that:

•

Cams are aligned across the wrist axis.

•

Struts are placed on the medial and lateral sides of the arm.

•

Cuff is evenly contoured across the arm, with enough space to slide

one finger under the upper and lower edge of the cuff.

•

Palmar bar is adjusted to conform to patient's palm.

STEP 15: Tape or mark the bottom-of-forearm cuff to prevent alteration of the fitting

by the patient.

STEP 16: Make a reference line with a marker on the top-of-forearm cuff and counter-

force strap so that the patient knows where to close them.

STEP 17: Have the patient practice applying and removing the unit.

Give the patient the Patient Instruction Booklet to take home with the Dynasplint®

Wrist Extension System.

Vertical Post

Horizontal

Bar

3-B Set

Screws

3-C Set Screws

3-A Set

Screws

Stem Rod

3-E Sagittal

Screw

3-D Wrist Pivot

Assembly

Palmar Bar