DCI DigiTrak FALCON F5 Sub-k Rebar 보충 설명서 - 페이지 8
{카테고리_이름} DCI DigiTrak FALCON F5 Sub-k Rebar에 대한 보충 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCI DigiTrak FALCON F5 Sub-k Rebar 16 페이지. Full scale sensitive pitch (fssp) frequency optimizer update and other recent updates
페이지 인쇄
D
C
IGITAL
ONTROL
Switching Bands
Switch the transmitter between Up and Down bands pre- or mid-bore using any of the methods described in
the Falcon F5 QSG or operator's manual.
On the receiver, hold-toggle right at the Locate screen to open the Band Selection Menu, where you can
switch between the optimized Up and Down bands and turn on fluid pressure monitoring.
The Up band is standard power with three bands encompassing a range of low frequencies.
l
The Down band is mid-power with three ultra-low bands (0.3, 0.5, and 0.7) specifically for depth/locates,
l
plus also uses the optimized Up band (7, 11, or 16) for data signal.
Band Selection Menu
Select Pressure to show fluid pressure transmitter data.
The FO graph does not show passive interference. The lowest band in the ultra-low frequency
range (0.3) is always best for passive interference alone. However, if active interference in
that band (shown on the FO graph) is exceptionally high, consider using 0.5 or 0.7.
4
I
NCORPORATED
1. Up or Down band
2. Pressure on/off
3. Locate mode
Supplement B for DigiTrak ® Falcon F5 ®