Dynastream Innovations AMP 231 사용자 설명서 - 페이지 11

{카테고리_이름} Dynastream Innovations AMP 231에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynastream Innovations AMP 231 17 페이지. Activity monitoring system

Taking Care of Your AMP Activity Monitoring Pod and Ankle Sleeve

The pod should be stored with the battery removed (see Replacing the Battery, below, for

instructions on removing the battery). The ankle sleeve can be washed in warm water with

a mild detergent and hung to dry.

Replacing the Battery

The pod uses one AAA battery, which is estimated to last more than seven days. When the

battery is low, the battery icon will flash. As the battery gets weaker, the icon will turn solid.

Power off the monitor before replacing the battery. The battery hatch is located on the flat

end of the pod and can be opened by turning the cap counter-clockwise with a coin. Insert

the battery with the positive end first. Data collected to this point will not be lost. However,

date and time settings must be updated before a new session is started.

AMP USB Stick and AMP Ware

The AMP USB Stick enables the AMP Activity Monitoring Pod to wirelessly upload data to

your computer using the supplied AMP Ware application.

Use the accompanying AMP 231 CD to install the AMP USB Stick drivers and the AMP Ware

application.

Computer System Requirements

Computer type

PC with USB port and CD-Rom

Windows® 2000, Windows ® XP

Operating system

Processor speed

Minimum Pentium 266

Available RAM

64 MB

Available hard disk space

<<graphic? USB stick photo, amp ware splash screen, etc.>>

Using AMP Ware

Follow the basic installation instructions to install the AMP USB Stick drivers and AMP

Ware.

When AMP Ware is launched, the following session information screen will appear. The

User ID# and Trial ID# fields must be filled in prior to data transfer. All other fields are

optional. Optional fields are saved as notes in the data file. With the appropriate fields filled

in, ensure that the USB stick into an available USB port on your computer, set the AMP

Activity Monitoring Pod to the upload mode (see Data – Upload, page xx), and click on

Download to begin the data transfer.

<<graphic – battery hatch >>

100 MB