DCI Edge DW5550 사용 설명서 지침 - 페이지 13

{카테고리_이름} DCI Edge DW5550에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DCI Edge DW5550 19 페이지. Side delivery system

ADJUSTMENTS

FLEX ARM TENSIONING

The Flex Arm is preset at the factory, however it may be necessary to re-adjust tension to the user's needs. After adjusting

the spring tension, the delivery system head must be leveled (see head leveling).

TO INCREASE SPRING TENSION

Remove the end cap at the front of the flex

arm and loosen the set screw in the knuckle

block which is located above and behind

the front knuckle adjustment screw using a

3/32" hex key (A).

Remove the end cap at the rear of the flex

arm and increase the spring tension by

rotating the adjustment screw in the rear

knuckle clockwise with a 3/16" hex key

(B). Retighten the knuckle block set screw

(A). Replace the end caps.

TO DECREASE SPRING TENSION

Remove the end cap at the front of the flex

arm and loosen the set screw in the knuckle

block which is located above and behind

the front knuckle adjustment screw using a

3/32" hex key (A).

Decrease the spring tension by rotating the

adjustment screw in the front knuckle

clockwise with a 3/16" hex key. Retighten

the stop block set screw. Replace the end

cap (A).

WARNING: Do not attempt to decrease spring tension by rotating the adjustment screw in the

rear knuckle counterclockwise. This might thread the screw out of the control rod causing the

delivery system to drop suddenly, damaging the equipment and the operator.

SERIES 5 SIDE DELIVERY SYSTEM

Instructions For Use

FRONT KNUCKLE

REAR KNUCKLE