Dynasty DY-BT44 설치 지침 및 운영 매뉴얼 - 페이지 5

{카테고리_이름} Dynasty DY-BT44에 대한 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynasty DY-BT44 9 페이지.
Dynasty DY-BT44에 대해서도 마찬가지입니다: 설치 지침 및 운영 매뉴얼 (8 페이지)

ELECTRICAL SPECIFICATIONS

Voltage ......................................120V AC, 60 Hz

Total Amps ...................................... ... 10.8AMP

Total Watts ........................................1300Watts

ELECTRICAL CONNECTION

WARNING! Electrical wiring must comply with local building codes and other applicable

regulations to reduce the risk of fire, electrical shock and injury.

Note: All wiring must be completed prior to finishing the unit.

EXISTING APPLIANCE INSTALLATION

Plan the power supply. If an existing grounded outlet is near the appliance, the power cord can run

behind the appliance. If the cord is not long enough to reach the outlet, a grounded extension cord

minimum AWG No. 14 wiring and rated to a minimum or 1875 watts may be used. To reduce the risk of

fire, do not run the power cord under rugs, carpets, etc. Arrange the power supply cord away from high

traffic areas where it may be pose a tripping hazard.

HARD-WIRE INSTALLATION

If it is necessary to hard wire this appliance, a qualified electrician may remove the cord connection, and

wire the appliance directly to the house hold wiring. The appliance must be electrically connected and

grounded in accordance with local codes.

·Remove the cord connection. (Figure 3)

·Wire to a properly grounded, 120volt, 60Hz, 15 AMP circuit.

·Ensure all junction block connections are tight. (Figure 4)

·Replace the cover and retaining screws.

figure 3

figure 4