DCI Edge SERIES 5 사용 설명서 지침 - 페이지 10

{카테고리_이름} DCI Edge SERIES 5에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DCI Edge SERIES 5 19 페이지. Side delivery system
DCI Edge SERIES 5에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (12 페이지), 설치 지침 매뉴얼 (11 페이지), 사용 설명서 지침 (8 페이지), 설치 지침 매뉴얼 (14 페이지), 설치 지침 매뉴얼 (13 페이지)

SERIES 5 SIDE DELIVERY SYSTEM

Instructions For Use

ADJUSTMENTS

UTILITY CENTER

The Utility Center comes factory preset at 40 psi for Water pressure and 80 psi for Air pressure. All regulator adjustments

should be made with the Master On/Off in the ON position.

1. TO INCREASE AIR AND/OR WATER PRESSURE: Turn the

knob clockwise to the desired pressure.

2. TO DECREASE AIR AND/OR WATER PRESSURE: Turn the

knob counterclockwise to the desired pressure.

NOTE: When decreasing pressure, pressure must be relieved from the system. This may be achieved by pressing the

syringe buttons to attain an accurate measurement from the gauges.

DRIVE AIR

Identify the adjustment knobs for

controlling drive air on the underside of the

control head as shown (right).

Install a bur in the handpiece that is to be

adjusted. The drive air adjustment screws

on the handpiece block correspond with

the handpiece positions on the holder bar.

Run the handpiece. With the foot

control plate fully depressed, turn

the corresponding adjustment screw.

Clockwise to decrease pressure,

counterclockwise to increase pressure.

Pressure Adjustment Knob

DRIVE AIR FLOW ADJUSTMENT

FLOW CONTROL

Pressure Gauge

DRIVE AIR

PRESSURE GAUGE