Autopilot ECLIPSE F90 사용자 설명서 - 페이지 7

{카테고리_이름} Autopilot ECLIPSE F90에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopilot ECLIPSE F90 12 페이지. Master environmental controller

페이지 인쇄

PPM SETTINGS

LEVELS: Click the CO2 PPM knob and turn to set the PPM target. Click again to confirm the

setting.

DEADBAND: Click the DEADBAND knob and turn to set the desired deadband setting. Click

again to confirm the setting.

Example: For CO

start to work at or below 1000 and turn off at 1050 PPM. For CO

or above 1000 PPM and turn off at 950 PPM.

MIN/MAX RECALL: Click and hold the CO

the CO

min/max PPM record. The display will show L XXX, H XXX. The screen will return to normal

display after 5 seconds (or immediately if you click both knobs simultaneously again), and the

record will be reset.

CALIBRATION: Place the CO

CAL/400, if you need to change the calibration level, turn the left knob. Keep the sensor from direct

sunlight and any breathing. Allow it 10 minutes to stabilize the PPM reading. The Screen will return

to normal display once the calibration is complete.

& TEMP LOCK/UNLOCK SWITCH

LOCK: This setting will not allow the CO

will always be deactivated when the Cooling outlet is activated On. Lock setting is recommended

for rooms applying CO

minimizes CO

loss when the exhaust fan is operating.

UNLOCK: The CO

enrichment device and any cooling device that is plugged in are independently

controlled.

TEMPERATURE SETTINGS

The unit offers both day and night temperature control. Select either the heating or cooling mode

option.

DAY TEMP SETTING: There is a Day Cooling set point and a Day Heating set point.

1. To set the Day Cooling, Click the DAY TEMP knob. "COOL" will be displayed. To change the

setting, turn the DAY TEMP knob to select your desired temperature. Click again to accept the

new setting.

2. "HEAT" will then be displayed. Turn the DAY TEMP knob to select your desired setting, then click

the knob again to save the new setting.

NIGHT TEMP SETTING: Night temps are set exactly the same way as described above for day

temps, but using the NIGHT TEMP knob this time.

TEMP MIN/MAX RECALL: Press the DAY TEMP and NIGHT TEMP knobs simultaneously to recall the

min/max temperature record.

TEMP UNIT: Press and hold the DAY TEMP and NIGHT TEMP knobs simultaneously knobs for 3

seconds, then turn the DAY TEMP knob to select the desired temperature unit (°F or °C). Press both

simultaneously again to confirm the setting.

HUMIDITY & TEMPERATURE (RH% & TEMP) LOCK/UNLOCK SWITCH

LOCK: This setting locks both the temperature and humidity outlets together making them operate

simultaneously. Example: if the sensor detects a reading outside of the programmed Temperature

setting the unit will activate both Temperature and Humidity outlets at the same time. Use this

OPERATING INSTRUCTIONS

increase mode, if setpoint=1000 PPM and deadband=50 PPM, the CO

sensor outdoors, press both knobs for 3 seconds, display screen reads

that are also operating an exhaust fan for temperature control. This setting

PPM and DEADBAND knobs simultaneously to display

and Temp outlets to run simultaneously. The CO

decrease mode, the fan will start at

output will

outlet