DCL Camatics VT2500 피팅 매뉴얼 - 페이지 4

{카테고리_이름} DCL Camatics VT2500에 대한 피팅 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCL Camatics VT2500 9 페이지.

3 I

NSTALLATION

OS AND

3.1 P

OWER

The device MUST be wired to its own power supply and not connected/shared with an existing power

pickup point. We recommend that the vehicle power pickup points should be located using the vehicle

manufactures instructions.

YOU MUST NOT USE ANOTHER TELEMATICS PROVIDER'S POWER SUPPLY

OR PICK UP POINTS TO POWER THIS DEVICE

To avoid interference the power supply MUST be installed as far away from other Telematics devices

and power supplies already installed within the vehicle as possible. Ideally on the opposite side of the

vehicle.

3.2 S

ECURING THE DEVICE

Please note the installation location on the windscreen MUST NOT be in the marked area "As shown

below"

The dash camera has an internal accelerometer to measure harsh driving events so you

MUST

ensure

that it is firmly secured in the vehicle.

You

MUST

ensure that the device is calibrated as part of the commission process.