Autopilot APCG8NG 매뉴얼 - 페이지 6

{카테고리_이름} Autopilot APCG8NG에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopilot APCG8NG 13 페이지. 4 burner co2 generator (lp or ng)

Page 5

APCG4

Start Up Procedure

After completing the installation, follow this start up procedure.

Verify the power switch is off and the unit is not plugged in.

Verify there are no foreign objects or loose packing materials

on the inside of the unit.

Make sure nothing appears damaged or out of place.

Check and confirm that the gas connections are connected

properly.

Pressurize the gas lines by opening any of the shut off valves

on the gas supply. Test for gas leaks especially if this is the

first time the unit will be used,

Make sure there are no objects within 20" of the surface of the

unit.

Plug in the 24 volt DC power supply into a 120 volt power

source. Then connect the small power cable to the power inlet

jack on the CO2 generator.

Turn the power switch ON. The green LED indicator light

should illuminate next to "Main Power On".

Shortly after, the ignition module will attempt to ignite the

burner(s) for approximately 5 seconds. The yellow LED

indicator light should illuminate next to "Pilot Valve On"

If the burners fire, continue to next step. If this is the first time

using this unit or the LP tank has been replaced recently, the

burners may not fire the first attempt. After a 30 second pause,

it will attempt to re-fire the burner(s) for 15 seconds. This cycle

will repeat until it fires or for a maximum of 5 tries.