Dynasty Fireplaces DY-BEF57 주택 소유자 설치 지침 및 운영 매뉴얼 - 페이지 11

{카테고리_이름} Dynasty Fireplaces DY-BEF57에 대한 주택 소유자 설치 지침 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynasty Fireplaces DY-BEF57 15 페이지.

The fireplace is packaged with a three prong plug installed for plug-in convenience.

Hard wiring the fireplace is also an option for any installation.



Plug in (you may run the power cord out of the framed wall opening to an

existing outlet or install an outlet on a nearby wall stud within the wall).

cord is not long enough to reach the outlet, a grounded extension cord minimum

AWG No. 14 wiring and rated to a minimum or 1875 watts may be used.



Hard wire the fireplace (recommended).

cord connection, and wire the appliance directly to the house hold wiring. The

appliance must be electrically connected and grounded in accordance with local

codes.

 Remove the 2 screws to release the cover of junction box.

 Remove the cord connection.

 Wire to a properly grounded, 120volt, 60Hz, 15 AMP circuit.

 Ensure all junction block connections are tight.

 Replace the cover and retaining screws.

OPERATION

This appliance can be operated by both remote control and manual button. Once the

unit has been properly connected to an earthed electrical outlet, turn on the main

switch. A beep should be heard when the power is first applied.

NOTE: To use both remote and manual functions, the main on/off switch must be

in 'on' position.

●

Operating by Manual Button

A qualified electrician may remove the

If the