Autoplugin RCP-V2 설치 매뉴얼 - 페이지 3

{카테고리_이름} Autoplugin RCP-V2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autoplugin RCP-V2 8 페이지. Volvo

Table of Contents

Installation procedure for plug-n-play connection.....................................

Connection schemes for permanent connection ........................................

Installation procedure for permanent connection........................................

Troubleshooting..............................................................................

Installation procedure for plug-n-play connection

Find the service connector at the left side of the dashboard, below the

lighting control switch.

Open the case of the service connector (if applicable).

Pass PnP-cable wires with white connectors on the end inside the dashboard,

beside of the service connector. Pull the wires inside the dashboard.

Connect white connectors of PnP-cable to RCP

Connect black connector of PnP-cable to the car's OBD-connector.

Turn ignition on to let the module get information from CAN-bus and wait

until LED goes off. Turn ignition off.

Check for the heater remote start by using Volvo key: turn on perimeter

lighting, then press Lock button twice.

Find place under the dashboard for the module and fix it with adhesive tape.

Shorten length of the cable by the strap

Close the case of the service connector (if applicable)

Note: if you need to unplug PnP-cable from OBD-connector (ex. to connect

diagnostic equipment to the car's electronic system), don't pull for the wires of the

cable! Pull for the housing of connector or for the special strap (if applicable).

Connection schemes for permanent connection

General connection scheme (fig.1, page 2)

Explanations to the scheme:

o It is enough to connect power wires (X1.8, X1.9) and CAN-bus wires

(X2.9, X2.10) to the module to obtain a possibility to start the heater using

Volvo remote key. You can use supplied PnP-cable for such a connection.

o The car's wiring marked in colour.

o Optional elements are outlined by dashes

Connection of the inputs Heater_on± and Heater_off±