High-Flying HF-LPT270 사용자 설명서 - 페이지 15

{카테고리_이름} High-Flying HF-LPT270에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. High-Flying HF-LPT270 18 페이지. Low power wi-fi + ble module
High-Flying HF-LPT270에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄
High-Flying HF-LPT270 사용자 설명서
HF-LPT270 Series Wi-Fi&BLE User Manual
Figure 7.
HF-LPT270 Order Information

1.2.8. Hardware Typical Application

Notes:
nReset- Module hardware reset signal. Input. Logics "0" effective.
There is pull-up resister internal and no external pull-up required. When module power up or some
issue happened, MCU need assert nRST signal "0" at least 10ms, then set" 1" to keep module fully
reset.
nLink- Module WIFI connection status indication. Output.
(This pin is recommend to connect to LED, indicate status when the module in wireless
upgrade mode)
When module connects to AP (AP associated), this pin will output "0". This signal used to judge if
module already at WiFi connection status. Thers is pull-up resister internal and no external pull-up
required. If nLink function not required, can leave this pin open.
nReady- Module boot up ready signal. Output. Logics "0" effective.
The module will output "0" after normal boot up. This signal used to judge if module finish boot up and
ready for application or working at normal mode. If nReady function not required, can leave this pin
open.
nReload- Module restore to factory default configuration.Input. Logics "0" effective.
(This pin is recommend to connect to button, is used to enter wireless upgrade mode)
User can de-assert nReload signal "0" more than 4s through button or MCU pin, then release, module
will restore to factory default configuration and re-start boot up process.. If nReload function not
required, can leave this pin open.
UART0_TXD/RXD- UART port data transmit and receive signal.
- 15 -
Shanghai High-Flying Electronics Technology Co., Ltd(www.hi-flying.com)