Autopot AquaValve 1Pot XL 설정 매뉴얼 - 페이지 2
{카테고리_이름} Autopot AquaValve 1Pot XL에 대한 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopot AquaValve 1Pot XL 2 페이지.
페이지 인쇄
1Pot XL module contents
• 1x 1Pot XL tray & lid
• 1x root control disc
• 1x 25ltr pot
* 1x 6mm tee connector
• 1x AQUAvalve
• 1x 16/6mm tee connector
• 1x 1.0 metres of 6mm pipe
Suggested layouts
47 ltr
Tank
1Pot XL System /
using 6mm pipe
225 ltr
FlexiTank
47 ltr
Tank
6Pot XL System / usong 6mm pipe
•
Pot up your plants, water through, then allow your plants to establish in the pots for a period of 7 to 10 days
before turning your system on. This will encourage a stronger and healthier root system.
•
Always raise your tank to a minimum of 150mm above the highest AQUAvalve and re-fill the tank when
there is approximately a 1/3 of the solution left - NEVER ALLOW THE TANK TO RUN EMPTY.
•
For best results, we recommend mineral fertilisers. Do not use organic fertilisers, as they have a tendency to
block small pipe work.
•
Clean all substrate from the bottom and sides of the pots before placing in each tray.
This will ensure your system is clean from the start.
•
Always use free draining substrates, for example: soil/perlite, coco/perlite, soil/clay pebbles,
coco/clay pebbles, rockwool/clay pebbles.
[email protected] I www.autopot.co.uk I +44 (0)844 8581520
Plan views
and options
Connect your 6mm pipe to the
relevant fitting
12Pot XL System / using 16mm pipe & 6mm pipe
Advice
1Pot XL dimensions
380mm
1
Place circular
root control disc
gold face down
in the pot.
3
Remove collar.
Push 6mm pipe through
collar
and
attach
AQUAvalve nozzle.
Rescrew collar - DON'T
overturn... when you feel
it grip STOP.
5
Position tray so it is
level.
7
According to the size of your system connect your
6mm/16mm pipe to relevant fitting or tank...
Using your front instruction sheet, repeat the module set up instructions for the number of trays.
Allow your plants to establish for 7-10 days before turning system on
Advice
If you require any guidance email - [email protected]
1Pot XL setup
330mm
instructions
25 ltr pot
275mm
2
Fill pot with medium
and pot up plants.
Water through pot
and allow to drain
outside the tray.
4
Connect AQUAvalve
to
so 'half moon' is on T
section in the tray.
6
Cut 6mm/16mm pipe
to appropriate length
8
Place
pot
tray, make sure it is
CLEAN!
Place lid over valve
onto tray.
in
the