Autopot easy2Propagate 간단한 관리 매뉴얼
{카테고리_이름} Autopot easy2Propagate에 대한 간단한 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Autopot easy2Propagate 2 페이지. Aquavalve5
페이지 인쇄
Ensure the silicone is sitting parallel
on the hole below it. Hold at eye level
to check the position is correct
Ensuring that the AQUAvalve5 floods
and drains correctly
Making sure your AQUAvalve5 floods and
1
drains correctly is simply achieved and
only takes a few seconds.
Hold the AQUAvalve5 at eye level so that
2
you can see the silicone fitted to the top
float resting on the hole below it.
The silicone must create a tight seal when
3
touching the hole.
If it looks like it is not sitting parallel on the
4
hole below, simply lift the top float and
apply pressure to one side of the silicone,
drop the float and hold at eye level again.
Repeat the procedure if necessary.
www.autopot-usa.com
Simple care
guidelines
Care and maintenance
At the end of your growing season, clean
1
the AQUAvalve5 using warm soapy water.
Using an old tooth brush will help.
The AQUAvalve5 is easily disassembled.
The top float will slide all the way across
and the bottom float is unclipped from its
pivoting position. The circular discs fitted to
the top float can also be removed by using
pliers to grip the raised point.
At this point is it advisable to remove the
silicones to avoid them being lost.
It is also handy to have a paper clip or pipe
2
cleaner to hand so that you can push it
through the AQUAvalve5 nozzle, this will
remove any lime scale build up that may
have occurred during the growing season.
Blowing through the AQUAvalve5 nozzle
will also help to remove any build up. Do
not under any circumstances use a drill &
drill bit to clear the AQUAvalve5 nozzle.
This
will
potentially
damage
the
AQUAvalve5 beyond repair.
Your complete
plant production facility
easy2Propagate
Lid
easy2Propagate
Basic Kit
easy2Propagate set-up guide
easy2Propagate
Complete Kit
easy2Propagate
Extension Kit