GalileoSky v 7.0 사용자 설명서 - 페이지 9
{카테고리_이름} GalileoSky v 7.0에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GalileoSky v 7.0 12 페이지. Installation and connection of galileosky tracking device
페이지 인쇄Installation and Connection of Galileosky Tracking Device
version 7 dated from 19.06.2018
Installation of Galileosky
components in a vehicle
Connection schemes
Galileosky tracking devices can be connected to on-board power system by three different
schemes. Riser diagrams and description of operation of these diagrams are shown in
Appendix №1 to this document.
1.
Connection from the battery (Pic. 12). The main way of connection provides constant
external power supply of the tracking device until the battery cut-off.
The order of connection is the following:
carry out 2 (two) direct wires of red and black color from the tracking device to the battery;
connect the black wire to the negative plug of the battery via 1A fuse;
connect the red wire to the positive plug of the battery via 1А fuse.
Fuse
2.
Connection from the battery with the battery disconnect switch (Pic. 13). It is the main way
of connection on vehicles which have a battery disconnect switch. It provides constant
external power supply of the tracking device until the battery cut-off.
The order of connection is the following:
use a dielectric spacer to isolate the tracking device from the car body and fix it by means
of dielectric fastener;
carry out 2 (two) direct wires of red and black color from the tracking device to the battery;
Fuse
Pic. 12
Connection from the
battery
9