DCN DCS-3950-28C 설치 매뉴얼 - 페이지 12
{카테고리_이름} DCN DCS-3950-28C에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DCN DCS-3950-28C 20 페이지. Dcs-3950 series dcs-3950-10c series dcs-3950-28c series
DCS-3950 series Installation manual
harmful gases will aggravate metal corrosion and the aging of some parts. The site should
avoid harmful gases, such as SO
the threshold value.
Gas
SO
2
H
S
2
NO
2
NH
3
Cl
2
2.1.1.2 Temperature and Humidity
The switch installation site should maintain a desirable temperature and humidity.
High-humidity conditions can cause electrical resistance degradation or even electric
leakage, degradation of mechanical properties and corrosion of internal components.
Extreme low relative humidity may cause the insulation spacer to contract, making the
fastening screw insecure. Furthermore, in dry environments, static electricity is liable to be
produced and cause harm to internal circuits. Temperature extremes can cause reduced
reliability and premature aging of insulation materials, thus reducing the switch's working
lifespan. In the hot summer, it is recommended to use air-conditioners to cool down the
site. And the cold winter, it is recommenced to use heaters. The recommended
temperature and humidity are shown below:
Temperature:
Long
term
condition
15~30℃
Table 2-3 Environmental Requirements: Temperature and Humidity
Caution!
A sample of ambient temperature and humidity should be taken at 1.5m above the
floor and 0.4m in front of the switch rack, with no protective panel covering the front and
rear of the rack. Short term working conditions refer to a maximum of 48 hours of
continued operation and an annual cumulative total of less than 15 days. Formidable
operation conditions refers to the ambient temperature and relative humidity value that
may occur during an air-conditioning system failure, and normal operation conditions
should be recovered within 5 hours.
, H
S, NO
2
2
Average (mg/m³)
0.2
0.006
0.04
0.05
0.01
Table 2-2 Environmental Requirements: Particles
Short
term
condition
0~50℃
Chapter 2 Hardware Installation
, NH
and Cl
, etc. The table below details
2
3
2
Max (mg/m³)
1.5
0.03
0.15
0.15
0.3
Relative humidity
Long
term
condition
40~65%
2-2
Short
term
condition
5% ~95%