Dynatech MP-3000 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Dynatech MP-3000에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatech MP-3000 16 페이지. Professional power amplifiers mp series

페이지 인쇄
Dynatech MP-3000 소유자 매뉴얼
PROFESSIONAL POWER AMPLIFIERS
1
1
1. Rack Mounting Ears.
Two front panel mounting holes are provided on each mounting ear.
2. AC Power Switch.
MP Series amplifiers have a front-panel main AC power switch .
3. Mode Indicated LED.
Yellow LED indicates `parallel` Mode, Green LED indicates `stereo` Mode, Red LED indicates `bridge`
Mode.
4. DynaTech Logo and Model No.
MP series have 4 type model MP-4000/MP-5000/MP7000 (3U model) /MP-3000(2U model).
5. Fan Inlet Grills and Filter.
MP Series amplifiers are cooled by two rear-mounted fans. Cool air from front grills are filtered and flows
over the heat sinks and exhausts to back side . Make sure these outlets remain clear to allow unrestricted
air flow.
6. Limiter Switch
You can select limiter on `on` for limiter working, and another mode is for limiter no working.
7. Input Attenuators.
Two input attenuators adjust level for their respective amplifier channels. In Bridged &Mono(parallel)
Mode.
8. Clip LED.
Illuminates at the clipping threshold. Continuous illumination also indicates that ACL (Active Clip
Limiting) protection circuitry is engaged.
9. Signal LED.
Illuminates to indicate that a signal (above a minimum threshold) is present at the amplifier input, and that
the signal is being amplified.
MP SERIES
MP-3000 (2U MODEL)
MP-4000 MP-5000 MP-7000 ( 3U MODEL)
2
3
4
2
3
4
MP-7000
PROFESSIONAL AMPLIFIER

Front Panel

5
5
6 7
8 9
6 7
8 9
Front Panel
Page 5