Dynatech V-3000 PLUS 사용자 지침 - 페이지 5

{카테고리_이름} Dynatech V-3000 PLUS에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatech V-3000 PLUS 14 페이지.

P R O F E S S I O N A L

P O W E R

A M P L I F I E R

Front Views & Rear Views | Introduction |

V-3000 PLUS / V-4000 PLUS Front Panel

1. Rack Mounting Ears - Two front panel mounting holes are provided on each mounting ear.

2. AC Power Switch - V PLUS Series amplifiers have a front-panel mains AC power switch.

3. Mode Indicated LED - Green LED indicates "parallel" Mode, Blue LED indicates "stereo" Mode, Green

indicates "bridge" Mode.

4. DynaTech Logo and Model No - V PLUS Series have 2 types of 2U models V-3000 Plus and V-4000 Plus.

5. Fan Inlet Grills and Filter -V PLUS Series amplifiers are cooled by two rear-mounted fans. Cool air from front

grills are filtered and flows over the heat sinks and exhausts to back side. Make sure these outlets remain

clear to allow unrestricted air flow.

6. Limiter Switch - You can select limiter on "ON" for limiter working, and another mode is for limiter no working.

7. Input Attenuators - Two input attenuators adjust level for their respective amplifier channels.

8. Clip LED - Illuminates at the clipping threshold. Continuous illumination also indicates that ACL (Active Clip

Limiting) protection circuitry is engaged.

9. Signal LED - These green and yellow LED's will glow according to the average signal output.

10. Protect LED - The red Protect LED will begin to glow when the channel goes into protect mode. When the

channel goes into protect mode all output for that channel will turn off. This is to protect any speakers

connected to the channel.

V-3000 PLUS / V-4000 PLUS

Front Panel

Figure 2

page 4