Dynatech D-BOX + VEGA A3 BETA 사용 지침 및 유지 관리 매뉴얼 - 페이지 4

{카테고리_이름} Dynatech D-BOX + VEGA A3 BETA에 대한 사용 지침 및 유지 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dynatech D-BOX + VEGA A3 BETA 8 페이지. Ucm unit

페이지 인쇄

D-Box + Vega A3 Beta + ASG 1XX + T-25 Instruction Manual

Date: 23-05-2017

Revision: 03

1 INTRODUCTION

1.1 DESCRIPTION

This system is made up of a D-Box signal control box, VEGA overspeed governor, T-25 steering mechanism and

ASG-1XX progressive safety gear, everything manufactured by Dynatech. This system operates as a complete

system of protection against car uncontrolled movements with the door open, also known as UCM.

This unit complies with the EN 81-20:2014 and EN 81-50:2014 standard by using the D-box as a signal management

system, the governor as a UCM detection component and the safety gears as braking components. The entire system

stops the car when a UCM occurs at a distance lower than 1 metre in accordance with the standard requirements.

This protection system is certified as detection and braking device in the scope of protection against car uncontrolled

movements with door open. Furthermore, each component making up the system has also been individually certified

for this purpose; obviously, without negatively affecting its certification as overspeed governor and progressive safety

gears when descending and braking component against overspeed when ascending.

UCM certification also includes the combinations between the different versions of these component models.

D-BOX + VEGA + ASG 1XX + T-25

ASG 1XX UD/ASD 1XX

The assembly of this safety package in an installation exempts the installation itself from requiring the UCM certificate

but not from checking that the unit is in compliance with the standard's requirements. The installer must be held

responsible for fitting the system in the installation and checking its correct working order.

2 RISKS AND SECURITY WARNINGS

2.1 RISKS

Electrical hazard

2.2 SECURITY WARNINGS



Reference to the manuals for use and maintenance of the different components making up the unit is

recommended.



The D-Box + Vega A3 Beta + ASG 1XX/ASG 1XX-UD + T-25/T-25 UD unit is valid for installations where the

P/Q ratio is above 0.7.



When a UCM occurs, a qualified technician is required for the installation to be operative again. Once the

problem causing the UCM has been solved, the reset button must be pressed in order to restore the safety

series and for the system to be operative again.

Note: This manual displays partial information on the instructions for use and maintenance of this product. Please refer to the customer

area in Dynatech's website in order to consult the full manual; http://customers.dynatech-elevation.com/

Cod: DYN 62-1.03

COMPONENT

D-BOX

VEGA

Do not handle or open the box with its terminals connected to

the D-Box's electrical power supply.

Never handle the VEGA overspeed governor's interlocking coil.

CERTIFICATE

TRI/DAS.IV-A/000020/16

CM/029-1/11

ATI/ LV/010

ATI/PP/010