Emerson Amphora F2200TG02 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Emerson Amphora F2200TG02에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Emerson Amphora F2200TG02 12 페이지. Derby & amphora series

페이지 인쇄

1. Assembly Instructions

WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX OR CIRCUIT BREAKER

BEFORE TROUBLE SHOOTING YOUR FAN.

TROUBLE

1. Fan will not start.

2. Fan sounds noisy.

3. Fan wobbles

excessively.

Trouble Shooting

PROBABLE CAUSE

1. Fuse or circuit breaker blown.

2. Loose power line connections to the fan, or loose

switch wire connections in the switch housing.

1. Blades not attached to fan.

2. Loose screws in motor housing.

3. Screws securing fan blade flanges to motor hub

are loose.

4. Wire connectors inside switch housing rattling.

Screws holding blades to flanges are loose.

1. Setscrew in motor coupling is loose.

2. Setscrew in hanger ball/downrod assembly is

loose.

3. Screws securing fan blade flanges to motor are

loose.

4. Fan blade flanges not seated properly.

5. Hanger bracket and/or ceiling outlet box is not

securely fastened.

6. Fan blades out of balance.

1. Check main and branch circuit fuses or circuit

breakers.

WARNING: Make sure main power is turned off.

2. Check line wire connections to fan and switch

wire connections in the switch housing.

1. Attach blades to fan before operating.

2. Check to make sure all screws in motor housing

are snug (not over-tight).

3. Check to make sure the screws which attach

the fan flanges to the motor hub are tight.

WARNING: Make sure main power is turned off.

4. Check to make sure wire connectors in

switch housing are not rattling against each

other or against the interior wall of the switch

housing.

5. Tighten screws securely.

1. Raise motor cover and tighten setscrew securely.

2. Tighten the setscrew in the hanger ball/downrod

assembly.

3. Check to be sure screws which attach the fan blade

flanges to the motor are tight.

4. Check to be sure the fan blade flanges seat firmly and

uniformly to the surface of the motor hub. If flanges are

seated incorrectly, loosen the flange screws and

retighten according to step 8 in the section "Assembly

Instructions".

5. Tighten the hanger bracket screws to the outlet box,

and/or secure outlet box.

6. Interchanging an adjacent (side-by-side) blade pair can

redistribute the weight and result in smoother operation.

Or use supplied balancing kit to balance blades.

SUGGESTED REMEDY