DCP LogIT DataMetern1000 사용 설명서 - 페이지 8

{카테고리_이름} DCP LogIT DataMetern1000에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DCP LogIT DataMetern1000 13 페이지.

R R R R e e e e f f f f e e e e r r r r e e e e n n n n c c c c e e e e

U U U U s s s s e e e e f f f f u u u u l l l l a a a a d d d d v v v v i i i i c c c c e e e e a a a a n n n n d d d d

p p p p r r r r o o o o d d d d u u u u c c c c t t t t i i i i n n n n f f f f o o o o r r r r m m m m a a a a t t t t i i i i o o o o n n n n

Remote Data-logging

Data can be stored in DataMeter without the need for a computer:

❷ ❷

Insert sensors

---

LogIT ❏❏

DataMeter 1000

˚C

21.5

---

LogIT ❏❏

DataMeter 1000

•Plan your experiment

Choose the sensor(s) you require and

plug them into DataMeter. You should

see the sensor's units and current

values appear on the screen

Tip you can use any sensor socket but

your graphs will look better if you start

from socket 1.

•AutoLog logging records

continuously over a period of time, up

to 3 months. You start AutoLog simply

by pressing the green button (or you

can use the menu). The flashing L L L L

indicates logging has started. You

can mark an event by pressing the

green button again. To stop logging

press the red button. You can now

transfer the data or log again (up to 4

sets)

•Snapshot logging stores sensor

readings when you press the green

button. Choose 'Start SnapLog' from

the setup logging menu. The red

button stops the logging session.

•Transferring logged data

DataMeter should be connected to

your computer in the same way as for

real time logging (see previous page)

but you need to select the load data

option from your software.

•Programmed logging

As well as AutoLog and Snapshot

logging you can also program

DataMeter to record at intervals you

select - see page 13 for more details.