DYNATEK DFCH-4 사용자 설명서 - 페이지 3

{카테고리_이름} DYNATEK DFCH-4에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNATEK DFCH-4 4 페이지. Fi controller

STEP 4

Unplug the connector from the TPS. Crimp

the wire tap onto the wire that is grey with a

purple stripe. This wire should be in position

"C" on the connector. Plug the grey wire from

the FI Controller into the wire tap.

STEP 5

Run the wiring harness for the FI Controller

from the engine to the seat. Make sure that it

will not get damaged when you reinstall the

tank. Use one of the wire ties to tie the wires

to the frame, away from the cylinder head.

STEP 6

Place the FI Controller where you plan on

mounting it permanently. In most cases, this

will be under the seat. Connect the ground

lug (black wire) to a grounding point on the

bike. Use the Velcro tape to mount the FI

Controller in position. Use alcohol swab to

clean mounting surface prior to attaching

Velcro.

Reinstall fuel tank and seat.

FI Controller

Part# DFCH-4

Installation