Highland HP6IFC-2 사용 및 관리 매뉴얼 - 페이지 9
{카테고리_이름} Highland HP6IFC-2에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Highland HP6IFC-2 20 페이지. Induction ceramic hob
페이지 인쇄Residual heat indication
After the heating zone is turned off, or the complete stop of the hob, the heating zones are still
hot and indicates [ H ] on the display.
The symbol [ H ] disappears when the heating zones may be touched without danger.
When the residual heat indicators are on, don't touch the heating zones and don't put any heat
sensitive object on them. There are risks of burn and fire.
Booster function
The Booster function [ P ] and the Double Booster [
heating zone.
If this function is activated the heating zones work for 10 minutes with an ultra high power.
Booster is needed for example to heat up large quantities of water rapidly, like for noodles
Start up / Stop the booster function:
Action
Start up the Booster
Stop the Booster
Start up / Stop the double booster function:
Action
Start up the Booster
Start up Double Booster
Stop the Double Booster
Stop Booster
Power management:
The whole cooking hob is activated with a maximum limit of power. When the booster function is
activated, and in order to exceed the maximum power, the electronic system reduces the power
level of other heating zones. The display will blink on [ 9 ] for a few seconds and then shows the
maximum of power allowed :
Heating zone selected
[ P ] is displayed
Timer
The timer is able to be used simultaneously with all heating zones with different time settings
(from 0 to 999 minutes) for each heating zone.
Setting and modification of the cooking time :
Action
Select the power level
Select the Timer
Decrease the time
Increase the time
After a few seconds, the [ min ] display stops with blinking.
The time is confirmed and the timer starts.
Control panel
slide to the end of the "SLIDER"
or press directly on the end of
the "SLIDER"
slide on the "SLIDER"
Control panel
slide to the end of the "SLIDER"
or press directly on the end of
the "SLIDER"
re-press key [ P ]
slide on the "SLIDER"
slide on the "SLIDER"
The other heating zone:
[ 9 ] goes to [ 6 ] or [ 8 ] depending the type of zone
Control panel
slide on the "SLIDER"
press simultaneously key [ - ] and [ + ] Timer display on
from the timer until the
desired display is on
press key [ - ] from the timer
press key [ + ] from the timer
9
] grants a boost of power to the selected
Display
[ P ]
[ 9 ] to [ 0 ]
Display
[ P ]
[
[ P ] to [ 0 ]
[ 9 ] to [ 0 ]
(example: power level 9)
Display
[ 1 ] to [ P ]
[ 60 ] to 59, 58...
Time increase
and P ]