Afinia 3D ES360 빠른 시작 매뉴얼

{카테고리_이름} Afinia 3D ES360에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Afinia 3D ES360 2 페이지.

Put the box on a stable surface, cut the tape and open the box.

Remove the inner box and open. Pull foam carefully from inner box

and pull foams apart. Carefully take out scanner and turntable; set

spare parts aside for now.

Adjust the angle of the scanner so the lower edge of the projec on

approaches the second loop of the turntable; ghten the scanner

mount bolt.

ES360 QUICK START GUIDE

www.aﬁnia.com

Assemble the frame for the Calibra on Board as shown in the image

above, then slide the calibra on board into the frame.

NOTE: During calibra on, the frame should not be moved - rotate the

calibra on board instead.

Set the turntable and scanner in the outlines on the posi oning sheet.

Grooves

should be open

at the top

Support Webpage:

aﬁnia.com/support

For Email Support:

support@aﬁnia.com

For Phone Support:

USA (M-F 8-5 CT):

952.279.2643

UK: +44 (0)845 230 7800

Japan:

03-3561-2266

Plug the power cable, VGA cable, and USB cable into the speciﬁed

connec ons on the scanner and turntable. Plug the other ends of

the cables into the computer and outlet. Turn on the scanner by

pressing the power bu on twice.

NOTE: The scanner USB cable can only be connected to the PC using

a USB 2.0 port.

360

To register your scanner and download the installer, go to

h p://www.3dker.com/en and create an account. Select the Aﬁnia

3D scanner model and enter your Serial Number to begin the down-

load.

A USB s ck with the so ware installer is also included with your

scanner.